Agent Command Line Options
The following command line parameters are available for the agent executable. Unless otherwise indicated, only a single option should be supplied.
| Option | Alias | Usage |
|---|---|---|
| -install | -i | This option is used to install the PerformanceGuard agent as a service on the computer |
| -deinstall | -d │ -u | This option is used to remove the service from the computer. If the service hasn’t been installed, it has no effect. |
| -run | -r | Use this option to run the agent directly from the command line. |
| -Restart | Use this option to restart (or start) the service. | |
| -StopService | Use this option to stop the service. | |
| -InstallGUI | -ig | Install the PerformanceGuard agent GUI interface. |
| -UnInstallGUI | -ug | Remove the PerformanceGuard agent GUI interface from startup. |
| Special Values | ||
| -RegBase=<key name> | Specifies an alternative base key for the agent to use. Default is “E2EAgent”. | |
| -Help | Prints command line help. | |
| -ConfigFile=<file name> | Read values from a configuration file in addition to reading the registry. ⚠️ The configuration file must be in ANSI format. |
|
| -WriteConfigFile=<file name> | Write configuration values to a named file, for example to copy values from the registry. ⚠️ The configuration file must be in ANSI format. |
|
| -IgnoreRegistry | Don’t read configuration values from the registry. | |
| -UpdateRegistry | Update the configuration values in the registry, for example to update registry from a configuration file. ⚠️ The configuration file must be in ANSI format. |